25' LOA Welded Aluminum Survey Boat

SOLD

Cabin / Twin Outboards / Stainless Props/ Air Conditioner / Pushknees / Aluminum Tandem Axle Trailer / Hydraulic Steering / Morse Controls / Large cabin / Cabinets / Wood Trim

Manufactured by:
Thompson Industries, Inc.
Bayou LaBatre, AL

1998 construction of 3/16ths plate

Boat measures 25' from back of props to front of pushknees. It measures 21' from front of pushknees to transdom

Boat is 8'3" wide at transdom, not including 3" on each side of D-section rubber, (8'9" total). Hull is slightly wider at midships, approx. max 9' wide at midships only, can be made 8'6" wide without rubber. Whole rig is about 30' from tip of trailer to tip of props.

Lots of storage, lots of headroom, lots of windows, large fully enclosed cabin, D-section rubber bumper

Needs painting but in good shape.

Motors are 175hp with Stainless steel props, hydraulic steering Morse controls.

This boat was used for shallow water hydrographic surveying. It has a frame which is bolted to the forward pushknees to protect the valuable survey equipment. It can be un-bolted just as easy. It also had a frame which went around the motors to portect them. The frame is gone but the welded pad-eyes are still there to simply bolt a new one back on.

The boat could be lifted (with caution) from the rear tow bits and the front pushknees.

Engines reported to run, top speed reported at 40-45 mph.

Open rear deck area 82" fore to aft, and 78" port to starbord. Rear deck is larger under gunwales.

Top of cabin needs weld repair where mast was, one fuel tank needs a hose.

Most photos below were taken 8/13/08

SOLD

Located at 5917 Hwy 90 East in Broussard, LA 70518

Call Jac Cloutier at 985-384-9517 or www.triplecmarine.com